Which command prints network connections, routing tables, and interface statistics?

The command is netstat, which is used to display network connections, routing tables, and interface statistics in Linux. It shows information about network activity on the computer.

Command:

netstat -a -r -i

Example:

If you want to check network connections, routing tables, and interface statistics in Linux, open the terminal and run the following command.

netstat -a -r -i

Output:

Active Internet connections
Proto  Recv-Q  Send-Q  Local Address  Foreign Address  State
tcp    0       0       0.0.0.0:22     0.0.0.0:*        LISTEN

Kernel IP routing table
Destination  Gateway      Genmask    Flags  Iface
0.0.0.0      192.168.1.1  0.0.0.0    UG     eth0

Kernel Interface table
Iface  MTU   RX-OK  TX-OK
eth0   1500  1200   900

Here:

By using the netstat command, you can see network connections, routing tables, and interface statistics in the output.